In this step I will install the DVD Burner, DVD Drive and a floppy drive. Again, as always, I have to unpack the items and check them for visual defects.
The first thing I will do is start installing the two DVD drives. I need to slide the drives into the appropriate slots in the computer case and secure them using four screws.
Sliding the first DVD drive into a slot |
|
Securing the First DVD drive to the case using the four screws |
|
The same procedure will be used as I install the second DVD drive.
Installing the second dvd drive |
|
Next I have to install the SATA power cables from the power supply and the SATA connectors from the motherboard.
SATA Power Connectors |
SATA Cables being Connected |
|
|
Note: I ended up moving the DVD drives down one slot each so I will have extra space because the power supply cables are so long. Again, this is only a mid atx case and I will have more room when I expand to a full case.
I will again repeat the procedure to install the final drive, which is the floppy drive. I will slide it into the appropriate slot and secure it to the case with the mounting screws. Then I will need to install the floppy drive cable and floppy drive power connector.
Floppy drive installed |
floppy drive cable |
|
|
Step 13: Installing Case Fans
